Safety Instructions
Installation of the range.
Read these instructions completely and carefully.
To Make Electrical Connection (if range has electric ignition)
Operating Instructions
■This appliance must be supplied with the proper voltage and frequency, and connected to an individual, properly grounded and polarized branch circuit, protected by a circuit breaker or
■Wiring must conform to National Electrical Codes or the prevailing local code for a range of this kilowatt rating. (See the rating plate under the cooktop for this information.)
■If the electric supply provided does not meet the above specifications, call a licensed electrician.
WARNING!
Electrical Grounding Instructions
This appliance is equipped with a three prong grounding plug for your protection against shock hazard and should be plugged directly into a properly grounded receptacle. Do not cut or remove the grounding prong from this plug.
INSURE PROPER GROUND EXISTS BEFORE USE.
Light and Adjust Surface Burner Pilots (if range has standing pilots)
Consumer Support Troubleshooting Tips
Purge all air from the supply system by setting one of the surface burner control knobs to HI for 15 seconds.
Turn the surface burner control knob to OFF and light the pilot burners with a match. (See the Lighting Instructions for Standing Pilot Models in the Using the surface burners section in this Owner's Manual.) Adjust pilot flames using the adjusting screw, accessed through a hole in the front right side of the burner box under the cooktop, so that each flame is approximately
To light any top burner, push and turn burner knob to the LITE position.
When burner has ignited, rotate knob to desired flame setting.
To adjust the pilots, lift and prop open the cooktop. Then use a small
Pilot adjustment
32