GE RGA624, RGA620 owner manual Oven Control, Air Adjustment, Care and Cleaning, Oven Shelves

Models: RGA624 RGA620

1 40
Download 40 pages 59.79 Kb
Page 11
Image 11
Oven Control

www.GEAppliances.com

Oven Control

Your oven is controlled by an OVEN TEMP knob. It will normally take 30-90 seconds before the flame comes on.

After the oven reaches the selected temperature, the oven burner cycles—off completely, then on with a full flame—to maintain the selected temperature.

Air Adjustment

Safety Instructions Operating Instructions

Loosen

Air Air Adjustment adjustment Care and Cleaning shutter Oven ShelvesInstallation Instructions Troubleshooting Tips Consumer Support

An air adjustment shutter for the oven burner regulates the flow of air to the flame.

You’ll find the shutter against the back wall behind the broiler door and valve shield. To reach it, remove the oven bottom (see the Care and cleaning of the range section), the burner baffle and the valve shield.

To adjust the flow of air, loosen the Phillips head screw and rotate the shutter to allow more or less air into the burner tube as needed.

When the right amount of air flows into the burner, the flame should be steady, with approximately 1/2 inch blue cones, and should not extend out over the baffle edges.

Replace the valve shield, burner baffle and oven bottom before operating the oven.

Care and Cleaning

Bump

Oven Shelves

 

 

The shelves are designed with stop-locks

 

so when placed correctly on the shelf

 

supports, they will stop before coming

 

completely out of the oven and will not

 

tilt when you are removing food from

 

them or placing food on them.

 

When placing cookware on a shelf,

 

pull the shelf out to the bump on the

 

shelf support. Place the cookware on the

 

shelf, then slide the shelf back into the

 

oven. This will eliminate reaching into

 

the hot oven.

 

To remove the shelves from the oven, pull

 

them toward you, tilt front end upward

 

and pull them out.

 

To replace, place shelf on shelf support

 

with stop-locks (curved extension of

 

shelf) facing up and toward back of oven.

 

Tilt up front and push shelf toward back

 

of oven until it goes past the bump on

 

the shelf support. Then lower front of

 

shelf and push it all the way back.

11

Installation Instructions Troubleshooting Tips Consumer Support

Page 11
Image 11
GE RGA624, RGA620 owner manual Oven Control, Air Adjustment, Care and Cleaning, Oven Shelves