Installation Instructions
SBSD137, SBSD227
For Washer Models: GBVH5140, GBVH6260, GCVH6260, GCVH6600, GHDVH626, GHDVH670, WBVH5100, WBVH6240, WCVH6260, WCVH6600, WHDVH626 and WHDVH660
For Dryer Models: DBVH510, DBVH512, DCVH515, DCVH660, DHDVH52, DHDVH66, PBVH415, PCVH565, PDVH515, PHDVH52 and PHDVH57
Instructions en français : . . . . . . . . . . . .4
Instrucciones en español: . . . . . . . . . . .8
BEFORE YOU BEGIN
Read these instructions completely and carefully.
•IMPORTANT — Save these
instructions for local inspector’s use.
•IMPORTANT — Observe all governing codes and ordinances.
•Note to Consumer – Keep these instructions with your Owner’s Manual for future reference.
•Completion time – 1 to 2 hours
•Proper installation is the responsibility of the installer.
•Product failure due to improper installation is not covered under the Warranty.
CAUTION — Due to the size and weight of these products, and to reduce the risk of personal injury or damage to the product, TWO PEOPLE ARE REQUIRED FOR PROPER INSTALLATION.
•See washer and dryer installation instructions for additional installation requirements and guidelines.
KIT CONTENTS
4 Support Pads
4 Mounting Screws
Drawer Divider
TOOLS YOU WILL NEED
Phillips Head
Screwdriver
9/16″ Open End Wrench or Adjustable Wrench
8 mm Socket Wrench
INSTALLATION PREPARATION
Remove the packaging.
The Drawer divider is taped at the top of the shipping carton. Remove the divider and set aside for final installation.
Flatten the product carton to use as a pad to lay the washer or dryer down on its side. Continue using the carton to protect the finished floor in front of the installation location.
1 REMOVE THE LEVELING LEGS
ACarefully lay the washer or dryer on its side to access the leveling legs on the bottom of the appliance.
IMPORTANT: Do not lay the washer or dryer on its back! Do not remove the shipping bolts on the back side of the washer. The bolts must remain in place until the washer is returned to an upright position.
BUse an
Back out and remove 
all 4 leveling legs
1
