Loading tips and suggestions
Controls and Features
Beverage Center
The bottom two full extension drawers hold five bottles each and are loaded with necks facing the rear. Tall bottles should not be loaded on the bottom drawer because they may prevent the door from closing.
•Do not block the thermistor, located on the right hand side, just above the top
shelf of the beverage center. Blocking the thermistor could impair the air circulation and temperature control.
NOTE: This unit is for storing beverages | Bottom drawer arrangement |
only and not intended for the storage of |
|
perishable foods. |
|
|
|
Removing full extension drawers
The bottom full extension drawers pull out so bottles can conveniently be added or removed.
The upper full extension slide can be removed for magnums or larger bottles.
To remove:
1.Pull the full extension drawer out to the STOP position.
2.Push the tab on right drawer guide down while pulling the tab on left guide up, and pull the drawer out.
To replace:
1.Push the drawer slide arm back into the unit.
2.Pull the small slide sub assembly completely forward.
Tab (push tab down on right drawer guide, pull tab up on left drawer guide)
Appearance may vary
To replace, push drawer slide | Pull small slide sub assembly |
arm back into unit | completely forward |
3. | Insert the sides of the drawer back | NOTE: Make sure the tabs on the full | |
extension drawer guides are fully engaged | |||
| into the guides. | ||
| before loading any bottles. Pull the drawers | ||
4. | Push until the tabs lock into place. | ||
out all the way to the STOP position and | |||
|
| push back in several times to make sure | |
|
| locking tabs are properly engaged. |
Wood drawer fronts
The full extension drawer fronts on the beverage center are unfinished cherry wood. During use, oil from hands may accumulate and stain the wood.
•The drawer fronts may be stained and sealed to match adjacent cabinetry. The tinted glass will make the stained wood appear darker. A true color match can be seen only when the door is opened.
•Apply the stain and sealer according to the manufacturer’s instructions. To avoid unpleasant odor, keep the door open to ventilate and allow the stain/sealer to dry completely before using the product.
NOTE: Natural wood may vary slightly in grain and color.
10