GE ZDBT240 Built-InDimensions, Installation dimensions, Product clearances, Product dimensions

Built-In Dimensions

Beverage Center

Installation dimensions

The beverage center can be a free- standing model or can be built in using the cut-out dimensions below.

233/4″233/4″

(603 mm) (603 mm)

When building in the beverage center, be sure to allow for a full door swing so you have full access to the pull-out full extension drawers.

See the Installation Instructions (Pub. No. 49-60210) for complete directions.

341/2″

(876 mm)

Product dimensions:		NOTE:	Cut-out dimensions:
Height: 341/2″ (876 mm)		Handle and	Height: 341/2–35″ (876–889 mm)
Width:	233/4″ (603 mm)	handle standoff	Width: 233/4″ (603 mm) minimum
Depth:	233/4″ (603 mm)	depth is 13/4″	Depth: 24″ (610 mm)

Product clearances

The beverage center is factory set for a 110° door swing.

When installed in a corner:

•Allow 4″ minimum clearance on the hinge side for the 90° door swing and to allow racks to slide out.

•Allow 10″ minimum clearance on the hinge side for a full 110° door swing.

•The door swing is reversible on all models. If desired, change the door swing before installation.

Choose the location:

10" Minimum

to Wall

110°

90° Door Swing

21-5/8"

23-5/8"

90°

4" Minimum

to Wall

•These products may be closed in on the top and three sides as long as the front is unobstructed for air circulation and proper access to the door.

•Do not install these products where the temperature will go below 55°F (13°C) or above 90°F (32°C).

•Do not install where it will be subject to direct sunlight, heat or moisture.

Black or Stainless Steel Toekick Options

These products are shipped with a black toekick installed. An optional stainless steel toekick is also supplied with each product. For shipping purposes, the stainless steel toekick is secured to the back or on the inside of the unit.

13