Installation
Installing custom 3/4 ″ door panel and handle
(cont.)
(ZIFI240 model
Assemble overlay panels with glue and screws:
1.Center spacer panel on the backer panel, left to right and top to bottom. Secure the panels with glue.
Overlay Panel
Spacer Panel
Backer Panel
onto the overlay panel before the panels are slid into the trim. Countersink all screws into the backer panel. Screws cannot protrude from the backer panel.
Screws Must
Be Countersunk
Into Panel
only)
2.Center the spacer/
backer panel on the overlay panel. Secure with glue and screws. Countersink all screws into the backer panel.
Custom Panel Hinge Routing Dimensions
Use a 3/4″ router bit to cut a notch
Handle
Custom 
Door Panels
into the back side of the assembled panel 3/8″ toward the front of the overlay panel, 3/4″ deep and 7/8″ wide.
4. Slide overlay panel into the door trim.
3/4″
7/8″ 
3/8″
3/8″ 
7/8″ 
3/4″
NOTE: Right hand models illustrated. Cut notches on the opposite side for left hand door swing.
Back side of custom panel
5.Reinstall the side trim using the trim screws removed earlier.
Install custom door panel and handle:
NOTE: Right hand models illustrated. Follow the same instructions on the opposite side for left hand models.
1.Open door to 90°.
2.Remove 5 screws holding trim; lift off trim. Retain screws.
3.A custom handle of your choice, supplied by your cabinet maker, must be installed
6.Place the brushed decorative cover over the side trim to hide the screw heads. Ensure side trim is aligned top to bottom and front to back. Snap into place.
NOTE: For shipping purposes the brushed decorative cover will be secured to the front of the unit.
15
