GE ZSC1202NSS ZSC1201NSS with ZX2201NSS, Dimensions and Installation Information in inches

ZSC1201NSS with ZX2201NSS

GE Monogram® Built-In Advantium® 120 Oven with Accessory Drawer

Dimensions and Installation Information (in inches)

ZSC1201NSS and ZX2201NSS Accessory - GE Monogram Built-in Advantium Oven and Accessory Drawer

Important: These installation cutouts include the ZX2201NSS accessory drawer.

ZSC1201NSS Advantium Installation with Accessory Drawer

ZSC1201NSS Advantium and Accessory Drawer Installed over a Monogram Oven

30"	23-1/2"
	21-1/2"
	Recessed
	Depth
	25-1/4"
	Min.
21"	22-1/4"
	29-3/4"

36-3/4"	Construct
	Base
Min.	Min. 3/8"
	Plywood
	Supported
	by 2x4 or 2x2
	Runners all
	Four Sides

Important: Any installation with an accessory drawer must be installed

36-3/4" minimum from the floor to the cutout. The combined Advantium and accessory drawer cannot be installed below a countertop.

36-3/4” Min.

45-1/4” Recommended

•Maintain 36-3/4" minimum height from the floor to the cutout in any single or combined installation.

•Allow 2-1/8" case trim overlap on the sides and 7/8" overlap on the bottom. Allow 1-1/8" overlap at the top of the oven.

Additional clearances between the cutouts may be required. See oven installation instructions for details.

ZSC1201NSS Advantium and Accessory Drawer Installed over a Monogram Warming Drawer

30"	23-1/2"	Construct Solid
		Bottom Min. 3/8"
		Plywood
	25-1/4"	Supported by
		2 x 4 or 2 x 2
		Runners all
		Four Sides
21"		2" Min
		Per Warming
		Drawer
		Requirement

36-3/4" Min.

Additional clearances between the cutouts may be required. Check to be sure the oven supports above the warming drawer do not obstruct the required interior depth and height. See warming drawer installation instructions for details.

For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000.

ZSC1201NSS Advantium and Accessory Drawer Installed over a Monogram Oven and Warming Drawer

30"	23-1/2"	Construct Solid
		Bottom Min. 3/8"
		Plywood
		Supported by
	25-1/4"	2 x 4 or 2 x 2
		Runners all
		Four Sides
21"		2" Min.

Per Oven

Requirement

2" Min.

Per warming drawer requirement

45-1/4"

Additional clearances between the cutouts may

be required. See warming drawer and oven installation instructions for details.

Listed by

Underwriters

Laboratories

Specification Created 11/08 130316