GE Monogram Bottom Mount Built-In Refrigerators manual Refrigerator location Clearances Leveling

Refrigerator location

Clearances

Leveling

	Preparation
		Bottom Mount Refrigerator
Do not install refrigerator where temperature	Do install it on a floor strong enough to support
will be below 60°F (16°C) because it will not	a fully loaded refrigerator.
run often enough to maintain proper
temperatures.
If the refrigerator is to be installed in a corner,	No other clearances at top, sides or back are
allow 2″ (51 mm) between the hinges of the	required.
refrigerator and the wall to assure a 90° door
opening capability.

This model has 4-point leveling. All 4 corners are supported by leveling legs. The front wheels are non-adjustable; they are only used for positioning the unit.

•To level the back of the unit, turn hex nut located above the front wheels.

• To level the front of the unit, use a 11/4″ open	Hex Nut
			Leveling Leg
end wrench and adjust the leveling legs.
• Turn hex nut or front leveling leg clockwise
to raise the unit, counter-clockwise to lower		Wheel
the unit.

See the Installation Instructions (Pub. No. 49-6983) for complete directions.

15