Stacking Instructions
WARNING:
•To reduce the risk of electric shock, disconnect this appliance from the power supply before attempting any user maintenance. Turning the controls to the OFF position does not disconnect this appliance from the power supply.
•Refer to the washer and dryer installation instructions prior to stacking appliances. Reading all of the information contained in these instructions will simplify the installation and ensure a correct and safe operation. A fire hazard and/or personal injury could result from improper installation.
TOOLS REQUIRED FOR STACKING THE DRYER
•Phillips head screwdriver
•
MOUNTING THE DRYER TO THE WASHER
The numbers in the illustration correspond to steps.
1.Remove the washer top panel by first removing the 4 screws in the 2 brackets located on the top rear of the washer.
Slide the top forward, lift the front of the top up and remove the top panel.
Remove the 2 brackets from the rear of the top panel.
2.Using the 4 screws that were removed in step 1, install the brackets in the rear support as shown.
3.Remove the 4 screws and the 2 long front brackets located on the top front of the washer.
4.Install the 2 new front mounting brackets provided and the 4 screws that were removed in step 3. Note that the tab of the front mounting bracket is facing forward as shown in the illustration.
19
