GE Monogram dimensions ZBD4700XWW-Dishwasher with stainless steel interior, Monogram

Monogram.™

ZBD4700XWW—Dishwasher with stainless steel interior

Dimensions and Specifications (in inches)

23 3/8"

4"

25 1/4"

From Inside Front Frame

5 1/2"

34" Min.

35" Max.

22 5/8"

Design Information: This dishwasher is supplied as a white model.

This dishwashers has a finished door and access panel. The door and access panel trim will accept custom panels up to 1/4" thick.

A toekick is supplied and may be covered with a custom toekick to match kitchen decor.

Side trim is not required. Side filler strips are supplied to fill a 24" wide opening.

Additional Specifications: A 120 Volt, 60 Hz power supply is required. An individual properly grounded branch circuit protected by a 15 or 20 amp circuit breaker or time delay fuse is recommended. Install a 3-prong electrical receptacle at least 6" above the floor and within 18" of the right or left adjacent cabinet wall. Wiring must enter the cutout in shaded area shown. A double, side-by-side installation requires two separate circuits.

The hot water line must enter the cutout in the shaded area from the right, left, rear or through the floor. The water line should be 3/8" O.D. copper or 1/2" O.D. plastic. Installation of an easily accessible hand shut-off valve is strongly recommended.

Toekick

3 3/16"

The dishwasher should be placed no more than 10 feet from the sink for proper drainage.

If the dishwasher is to be located in or near a corner of base cabinets, allow 2" min. clearance from the corner to prevent interference with adjacent door handles.

34" Min.

35" Max.

Underside of

Countertop

to Floor

Revised 7/97

This Wall Area

Must be Free of

Pipes or Wires

	24"
1-3/4"	Min.
Plumbing and Electric Service
Must Enter Inside This Area
	6"
23-5/8" Min.
24" Max.

For answers to your GE Monogram,™ GE Profile,™ GE, Hotpoint and RCA appliance questions, call GE Answer Center® service, 800.626.2000.

UL	Listed by
	Underwriters

RLaboratories