Installation Instructions
STEP 9 CONNECT DRAIN LINE
FOLLOW ALL LOCAL CODES AND ORDINANCES.
•The dishwasher is supplied with a 72" long drain hose.
•If a longer drain hose is required, add up to 48” of length for a total of 10 ft. length.
•Secure the drain hose to the air gap, waste tee or disposer with clamps.
•Make sure drain hose is not kinked.
IMPORTANT: When connecting |
|
|
|
|
| Remove | ||
|
|
|
| |||||
drain line to disposer, check to be |
|
|
|
| Plug | |||
sure that drain plug has been |
|
|
|
|
|
|
| |
|
|
|
|
| ||||
removed. DISHWASHER WILL NOT DRAIN IF PLUG IS LEFT IN PLACE.
Method 1 – Air gap with waste tee or disposer
Waste Tee Installation | Disposer Installation |
Method 2 – High drain loop with waste tee or disposer
Waste Tee Installation
Fasten to underside | Fasten to underside |
of countertop | of countertop |
30" | 30" |
12" Min. | 12" Min. |
Min. | Min. |
|
Disposer Installation
Waste Tee Installation
STEP 10 CONNECT ELECTRICAL
FOR DIRECT WIRE ONLY
(If a power cord with plug is used, plug it into the wall outlet and continue with next step.)
Verify that power is turned off at the source.
| Ground | |
Insert power cord wires |
| |
through strain relief and | White | |
tighten. | ||
|
Black |
•Locate the three dishwasher wires, (white, black and green) with stripped ends. Insert wire through the small hole in the junction box. Use wire connectors to connect incoming ground to green, white to white and black to black.
•Install junction box cover with screws provided. Check to be sure that wires are not pinched under the cover.
•Reinstall Insulation Board in position. The board should be secured so it does not interfere with door opening.
If house wiring is not
AVERTISSEMENT Si l’installation électrique de la maison n’est pas à deux fils plus terre, l’installateur doit installer un fil de
mise à la terre. Si l’installation électrique de la maison est en alu- minium, il faut prendre soin d’utiliser des composés antioxydants et des
connecteurs aluminium à cuivre sur la liste UL.
12
