Installation Instructions
BEFORE YOU BEGIN:
CUSTOM PANEL INSTALLATION: If you intend to install custom door panels, (on some models) refer to trim kit installation instructions. Custom panels should be in place before installing the dishwasher.
STEP 1 REMOVE PACKAGING
Cut the shipping carton and use it as a pad beneath the dishwasher. This will protect the finished floor in the kitchen.
•Remove wrapping and uncoil the drain hose in the back of the dishwasher. Do not remove rear insulation blanket.
•Lay the dishwasher on it’s back. Do not kink or crush the drain hose.
STEP 2 INSTALL LEVELING LEGS
Remove
Red Plugs
| Unscrew | |
Rear | Rear Legs to | |
Installation | ||
Insulation | ||
Height | ||
Blanket | ||
|
•Measure installation opening from the floor to the bottom of the countertop.
•Install the front leveling legs into holes on the brack- ets. Use a wrench to screw the legs in until the overall height of the dishwasher is 1/4" less than the installa- tion opening height.
Note: Install the legs as shown,
•Remove and discard the red plugs from the front holes.
STEP 3 REMOVE ACCESS COVER
Insulation Board
Junction Box
Access Cover
•Remove sound insulation board and the access cover plate.
•Install UL listed strain relief on junction box.
STEP 4 INSTALL 90° ELBOW
90°
Elbow
Thread Seal Tape
•Install the 90° elbow onto the water inlet. Use thread seal tape or pipe thread compound. Thread seal tape should be wrapped in same direction as the threads on the elbow.
•The 90° elbow should face the inlet water line.
10