GE Monogram ZDIW50 Drain Pump, Check Operation, Installation Instructions

INSTALLATION INSTRUCTIONS

(continued)

DRAIN PUMP

•When the drain connection is below the level of the icemaker, a drain pump may be used to lift the water to an available drain. Use only an approved drain pump kit ZDK50 from your dealer.

•Complete installation instructions are included with the drain pump kit.

CHECK OPERATION

•Start the icemaker by turning the service switch to “ON” and opening the line water valve.

•NOTE: Left is “OFF”—Middle is “ON”—Right is “CLEAN.” In “CLEAN” position, only the pump operates.

•Check the condenser fan to make sure it is revolving.

•Water will not enter the pump pan until the freezing plate gets cold and the icemaker goes into a harvest cycle.

•Check for even water flow over the freezing plate. The icemaker must be level for proper operation.

•Check for desired cube thickness and after 24 hours adjust if necessary. Maximum ice yield will be obtained with ice thickness at 1/2″ to 5/8″.

•Replace the grille.

18