REVERSING THE DOOR SWING
TO REVERSE THE DOOR
1.Remove the top hinge pin using a 1/8″ Allen wrench.
2.Lift the door off the bottom hinge.
3.Replace the hinge pin in the top hinge.
4.Switch the top and bottom hinges and move them to the other side. See illustration.
5.Insert the white plug buttons into the old hinge holes.
6.Unscrew the light trigger from the door bottom and insert the gray plug buttons into the holes on the door.
7.Before turning the door upside down, new holes will need to be drilled for the light trigger. Be careful not to drill down more than 1/2″ or you may damage the door glass. Measure 121/4″ from the right side and make a mark. Measure 3/4″ over from the first mark and make a second mark. Measure 11/16″ in from the front edge of the door and make a mark. See illustration. This is where the new holes will be drilled using a 5/32″ drill bit. Install the light trigger.
8.Remove the top hinge pin.
9.Turn the door upside down and place the door on the bottom hinge pin.
10.Screw the top hinge pin into the door.
11.Remove the old nameplate and stick the new Monogram nameplate on the door using the template included.
| Top Hinge |
| Bottom Hinge |
Light Trigger |
|
Top of the Door |
|
11/16″ | 3/4″ |
| |
| 121/4″ |
Front of the Door | |
9
