How to remove packaging tape

Care and Cleaning of the Oven

Trivection™ Wall Oven

BE SURE ELECTRICAL POWER IS OFF AND ALL SURFACES ARE COOL BEFORE CLEANING ANY PART OF THE OVEN.

To assure no damage is done to the finish

Apply with a soft cloth and allow to soak.

of the product, the safest way to remove the

Wipe dry and then apply an appliance polish

adhesive left from packaging tape on new

to thoroughly clean and protect the surface.

appliances is an application of a household

NOTE: The plastic tape must be removed from all

liquid dishwashing detergent, mineral oil or

chrome trim. It cannot be removed if it is baked on.

cooking oil.

 

Oven light bulbs

WARNING

SHOCK OR BURN HAZARD: Before replacing oven light bulb, disconnect the electrical power to the oven at the main fuse or circuit breaker panel. Failure to do so may result in electric shock or burn.

CAUTION

BURN HAZARD: The glass cover and bulb should be removed when cool. Touching hot glass with bare hands or a damp cloth can cause burns.

To remove:

1Turn the glass cover counterclockwise 1/4 turn until the tabs of the glass cover clear the grooves of the socket. Wearing latex gloves may offer a better grip.

2Using gloves or a dry cloth, remove the bulb by pulling it straight out.

To replace:

1Use a new 120/130-volt halogen bulb, not to exceed 50 watts. Replace the bulb with the same type of bulb that was removed. Your model will have one of the two types shown on the right. To determine the correct replacement bulb, check the bulb terminals. Bulbs with 2 straight pin terminals are G6.35 bulbs. Bulbs with 2 looped terminals are G9 bulbs. (Do not interchange.) Be sure the replacement bulb is rated 120 volts or 130 volts (NOT 12 volts).

2Using gloves or a dry cloth, remove the bulb from its packaging. Do not touch the bulb with bare fingers. Oil from skin will damage the bulb and shorten

its life.

3Push the bulb straight into the receptacle all the way. Then replace the screen. NOTE: The screen must be replaced or the life of the bulb will be reduced.

4Place the tabs of the glass cover into the grooves of the socket. Turn the glass cover clockwise 1/4 turn.

For improved lighting inside the oven, clean the glass cover frequently using a wet cloth. This should be done when the oven is completely cool.

5Reconnect electrical power to the oven.

ReceptacleSocket

G6.35 Bulb

Screen

Tab

Glass cover

(on some models)

ReceptacleSocket

G9 Bulb

Screen

Tab

Glass cover (on some models)

Receptacle

Use gloves or cloth

37