Installation
Stainless Steel G a s Cooktop
Step1
Install Cooktop
•Remove packaging from the cooktop.
•Position the cooktop over the opening, making sure that the power cord is dropped into the cabinet.
•Lower the cooktop into the cutout, pressing gently and evenly to seat.
•Thumbscrew brackets are located on the right and left sides of the cooktop.
•Turn thumbscrews to touch the underside of the countertop until just finger tight. Do not overtighten.
Cooktop
Countertop
1" Min.
NOTE: Countertop must be a minimum of 1" thick at the thumbscrew locations.
Thumbscrew
Step2
Install
Pressure
Regulator
•Install the supplied pressure regulator and nipple in the gas line as close to the cooktop inlet as possible.
•Install a manual
NOTE: Instead of using solid piping to connect to pressure regulator, an approved flexible metal appliance connector may be used between the pipe stub and the
NOTE: Refer to flow direction arrow on underside of regulator.
To Cooktop
Regulator
Solid Piping or Flexible Connector
Valve
Pipe Stub From
House Gas Supply
–Appropriate flare nuts and adapters are required at each end of the flexible connector.
•Turn on the gas. Check for leaks using a liquid leak detector at all joints in the system (the pressure test fitting is on the side of the regulator).
CAUTION Do not use a flame to check for gas leaks.
PRUDENCE IL NE FAUT PAS UTILISER DE FLAMME POUR VÉRIFIER S’IL Y A DES FUITES.
IMPORTANT: Disconnect the cooktop and the individual
7