Step3
Connect electrical
Installation
Stainless Steel G a s Cooktop
•Check to be sure the receptacle is properly wired by checking for proper polarity and grounding.
•Plug in power cord.
Step4
Assemble burners, check ignition
•Remove tape on burners.
•Assemble burner as shown. Check to be sure that burner heads and caps are securely seated. Pin(s) must completely engage holes to ensure proper assembly.
•Check for proper ignition:
–Push in one control knob and turn 90° to HIGH position.
–The igniter will spark and the burner will light; the igniter will cease sparking when the burner is lit.
–First test may require some time, while air is flushed out of the gas line.
–Turn knob to OFF.
–Repeat the procedure for each burner.
IMPORTANT: If the ignitor electrodes continue to spark after the burners are lit, check that each burner component is assembled and seated properly by observing constant gaps between each layer. Disassemble and reassemble as required.
To aid reassembly, each brass Burner Head is marked with a clock face. Replace the Burner Head with the arrow pointing to the rear of the cooktop (12 o’clock position).
8
