GE Monogram ZICS360 LH Level Refrigerator, Secure Refrigerator To Cabinetry, Prudence

Installation Instructions

STEP 5 LEVEL REFRIGERATOR

All models have 4-point leveling. The front is supported by leveling legs, the rear is supported by adjustable wheels. Both are accessible from the front of the refrigerator.

•To level the back of the refrigerator, turn the 7/16" hex nut located above the front wheels. Turn clockwise to raise or counterclockwise to lower the refrigerator.

•For front leveling, use a 1-1/4" open-end wrench.

•Adjust height of refrigerator to match installation cutout opening 83-1/2 to 84-1/2". The refrigerator should be level and plumb with cabinetry.

Hex Nut Adjusts

Rear Wheels

Leveling Leg

CAUTION:

The rear leveling wheels and front leveling legs are limited to a maximum height adjustment of 1". If the installation requires more than 84-1/2" height, the installer should elevate the refrigerator on a sheet of plywood or runners. Cabinetry trim could also be added across the top of the opening to shorten the opening. If you attempt to raise the refrigerator more than 1", you will damage the front leveling legs and the rear leveling wheels.

PRUDENCE

Les roues de nivellement arrière et les pattes de nivellement avant permettent un réglage maximal de 25 mm (1 po). Si l’ouverture pour le réfrigérateur a une hauteur supérieure à 2,15 m (84-1/2 po), l’installateur doit élever le réfrigérateur sur une feuille de contre-plaqué ou des glissières. Il est également possible d’ajouter des baguettes de finition des placards sur le haut de l’ouverture afin de la réduire. Lever le réfrigérateur de plus de

25 mm (1 po) endommage les pattes de nivellement avant et les roues de nivellement arrière.

STEP 6 SECURE REFRIGERATOR

TO CABINETRY

Whenever possible, perform this step for anti-tip security, or when anti-tip brackets cannot be used.

The refrigerator must be secured to prevent tipping.

•Raise the grille panel to access case trim.

•Drill hole in trim and drive screw through the trim into adjacent cabinet.

•Follow the same procedure on the opposite side.

Drive Screws

Through Case Trim and Into

Adjacent Cabinets

12