GE Monogram ZICS360 LH Connect Water Supply, Connect Power, Start Icemaker, Copper Tubing

Installation Instructions

STEP 10 CONNECT WATER SUPPLY

House	Refrigerator
Water Supply	Water Supply

•Locate and bring tubing to the front of the cabinet.

•Turn the water on to flush debris from line. Run about a quart of water through tubing into a bucket, then shut off water.

Copper Tubing:

•Slip a 1/4" nut and ferrule (provided) over both ends of the copper tubing. Insert tube into the union fitting on the unit and tighten nut to union.

•Turn on the water to check for leaks.

GE SmartConnect™ Tubing:

•Insert the molded end of the tubing into the refrigerator connection. Tighten the compression nut until it is just hand tight.

•Tighten one additional turn with a wrench. Overtightening can cause leaks!

•Turn on the water to check for leaks.

Note: Make sure excess tubing length does not interfere with drawer closing or toekick installation.

STEP 11 CONNECT POWER

•Check to be sure the power cord is plugged into the receptacle.

Raise

Grille

Panel

Electrical	Master Light
Outlet	Switch

•Check to make sure power to refrigerator is on by opening refrigerator door to see if interior lights are on.

•The temperature controls are preset at 37°F

for the fresh food section and 0°F for the freezer.

•Allow 24 hours to stabilize before making adjustments.

STEP 12 START ICEMAKER

Power Switch

Feeler Arm

•Flip the switch to I (ON). The icemaker will begin operation automatically.

•Be sure nothing interferes with the sweep of the feeler arm.

•Discard the first full bucket of ice cubes.

•To turn the icemaker off, set the switch to O (OFF).

16