GE Monogram ZISW36D INSTALLATION ~QUImMENTS, PmPAWTION, WORTANT.. .Please Read CarefuUy, Leveling

INSTALLATION ~QUImMENTS

WORTANT.. .Please Read CarefuUy.

How to connect electricity

For personal safety, this appliance must be properly grounded.

The power cord of this appliance is equipped with

athree-prong (grounding) plug which mates with a standard three-prong (grounding) wall outlet (Fig. 1) to minimize the possibility of electric shock hazard from this appliance.

DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE THE T~RD (GROUND) PRONG FROM THE POWER CO~.

DO NOT USE AN ADAPTER PLUG TO CONNECT THE REFRIGERATOR TO A TWO-PRONG OUTLET.

DO NOT USE AN EXTENSION CORD WITH THIS APPLIANCE.

Fig. 1

INSURE PROPER GROUND EXISTS BEFORE USE

The refrigerator should always be plugged into its own individual electrical outlet—(] 15 volt, 60 Hertz, single phase AC—protected by a 20-amp time delay fuse or circuit breaker). This is recommended for best performance and to prevent overloading house wiring circuits, which could cause a fire

Have wall outlet and circuit checked by a qualified electrician to make sure outlet is properly grounded.

Where a standard two-prong wall outlet is encountered, it is your personal responsibility and obligation to have it replaced with a properly grounded three-prong wall outlet.

hazard from overheating wires.

IMPORTANT: The water line and the electrical outlet must be installed in the exact location described in the Installation Instructions (Pub. No. 49-6445).

PmPAWTION

Refrigerator Location

Install the refrigerator on a floor strong enough to support it when it is fully loaded.

Do not install refrigerator where temperature will go below 60°F. because it will not run often enough to maintain proper temperatures.

Clearances

If the refrigerator is to be installed in a corner, allow 2“ between the hinges of the refrigerator and the wall to assure a 90° door opening capability.

No other clearances at top, sides or back are required.

Leveling

This model has 4-point leveling. All four corners are

supported by leveling legs. The front wheels are non-4 adjustable; they are only used for positioning the unit.

●To level the back of the unit, turn hex nut located

above the front wheels.

●To level the front of the unit, use a 1 Y4° open end wrench and adjust the leveling legs.

●Turn hex nut or front leveling leg clockwise to raise the unit, counter-clockwise to lower the unit.

See the Installation Instructions (Pub. No. 49-6445) for complete directions.

17