Before Using Your Icemaker and Dispenser
If you use your refrigerator |
|
|
|
|
|
| Ice |
before the water connection is |
|
|
|
|
|
| access |
made, raise the ice access door |
|
|
| door | |||
| I | w | |||||
and make sure the icemaker |
|
|
|
|
|
| Icemaker |
feeler arm is in the STOP (up) |
|
|
|
|
|
| |
|
|
|
|
|
|
| |
position as shown below. |
|
|
|
|
| 9 |
|
|
|
|
|
| |||
arm in (up)
n
water line and to fill water reservoir automatically.
Ice cube mold automatic fills with water after cooling to freezing temperatures. First cubes normally freeze after several hours.
NOTE: With a newly- | m in |
installed refrigerator, | n) |
|
allow about 24 hours for
the freezer compartment to cool down to the proper
Once Your Icemaker and Dispenser are in Operation
Throw away the first few batches of ice cubes
(16 or 24 cubes). This will flush away any impurities in the water line. Do the same thing after vacations or extended periods when ice isn’t used.
Discard the first six glassfuls of water in the kitchen sink. This will eliminate the slight “plastic” taste temporarily imparted to the water by the water reservoir.
Keep ice level to keep icemaker productive. Cubes ejected into an empty storage bin will pile up close to the icemaker and push the feeler arm up to the STOP position prematurely when the bin is only partially full. Open the ice access door, reach in, level the cubes by hand and icemaking will resume. Keeping cubes distributed evenly will allow the icemaker to produce enough ice to fill the bin to its maximum capacity.
Caution:
Under cefiin rare circumstances, ice cubes may be discolored, usually appearing with a green- bluish color. The cause of this unusual discoloration is apparently du~ to a combination of factors such as cefin characteristics of local waters, household plumbing and the accumulation of copper salts in an inactive water supply line which feeds tie icernaker. Continued consumption of such discolored ice cubes maybe injurious to health. If such discoloration is observed, discard the ice cubes and contact your GE Factory Service Center or an authorized Customer Care” Servicer.
To Dispense Ice and Water
For ice, set selector switch to CUBED, CRUSHED or
CHILLED WATER.
Grip glass or other container gently near the rim and press rim firmly against dispenser cradle.
I CAUTION: Never put fingers orother objects into theicecrusher discharge opening. | I |
|
I | I | (continued next page) |
|
|
7
