CALLER I.D. DISPLAY LOG

The features described in this section are only available if you subscribe to a Caller Display service from your network provider.

Caller Display means you can see who is calling on your LCD display (provided the number is not withheld, unavailable or is an international call). When your telephone rings, the time, date, the caller’s phone number and name and a count number (1-99) is displayed on the LCD display. The most recent call will have the highest count.

Every received call that is not answered is stored in the call log and the new calls count together with total calls count displayed on the standby screen increases by one. The LCD display will return to standby 10 seconds after the last ringing burst if the call is not answered.

This new call will also activate the new call indicator to blink. This will continue to blink until the new calls are reviewed and saved/deleted in the call log.

Note: Area code and LDS code must be set correctly (see Settings chapter) for the telephone to recognize and dial calls from the Caller Display log.

If the caller does not wish to show his phone number or his name, the screen will display ‘PRI- VATE’.

If the number is unknown from the telephone centre (international incoming call for example), the screen will display ‘OUT OF AREA’.

To review the new calls, use the or keys. When all new calls have been reviewed, the new call LED will disappear and the screen will come back to idle state after a few seconds. The total number of incoming call entries on the incoming call log will still be displayed on the screen. When the incoming call log is empty (if records have been deleted for example) the screen will display ‘00’.

Use a Number from the Caller I.D. Display LOG

There are two ways to use numbers from the call log. Firstly, Þnd the number and then lift the handset:

Use or to access the log and scroll until you Þnd the

required number for dialling

Lift the handset or press SPKR or press Headset (if headset

plugged in), the number will be automatically dialled

Alternatively you can lift the handset and then Þnd the number:

Lift the handset and then use or to access the log and

scroll until you Þnd the required number for dialling

Press OK and the number will be automatically dialled

Note: You cannot use either of these methods to recall a number that displays PRIVATE or OUT OF AREA.

25

Page 25
Image 25
Geemarc AMPLI500 manual Use a Number from the Caller I.D. Display LOG