8
GENERAL SETTINGS1 - HOW TO CONNECT THE PHONE AND SET THE BATTERIES
1 - Plug the adaptor in the power wall socket and the power plug in
the base socket (*).
2 - Connect the line cord plug to the base socket (**).
3 - Connect the line cord to the PTT socket.
4 - Insert the batteries with the correct polarity into the batteries
compartment and replace the battery cover.
5 - Place the handset on the base unit then a short beep will be heard
and the battery symbol will flash on the display, except if the
batteries are totally empty.
NOTE: Do not expose the base to electric equipment like TV, radio, monitors,
sunlight, heat or other phones...to avoid any disturbances of your phone.
(**) Classified TNV-3 according to EN60950 standard.
(*) Classified “hazardous voltage” according to EN60950 standard
2 - CHARGING THE BATTERIES
The phone is supplied with NiMH rechargeable batteries. In standby mode,
batteries are fully charged around 170 hours and talk time is around 8 hours.
The battery charge icon will flash as long as the phone is being charged
and will stop when the charging process is complete. The phone has an
automatic charging control to avoid excessive charging.
IMPORTANT: Batteries must be charged during 24 hours before using
the phone for the first time.
Battery charge icon:
The handset display shows when the batteries are flat and when a warning
signal is heard. If the phone does not have enough power or is not completly
recharged, it switches itself off automatically until it is returned to the base
unit.