7.STEAM IRONING
1.Fill the iron as described in Section 3 “Filling the water reservoir” and plug in the iron. Press the “increase temperature” regulator (6) to turn on the unit.
2.The LCD screen (4) will show all the symbols at once and you will hear a beep. Then the screen will show Point 1 and the iron will start to heat up.
3.Select the right temperature. See Section 4 “Setting the temperature”.
4.Select the steam option by pressing the steam
button (5). The iron will give a whistle and
the symbol will start flashing. Wait until the symbol appears on the screen indicating that the steam is ready
5.When you want to disconnect the steam, again
press the steam button (5). The |
|
|
|
|
| symbol will |
|
|
| ||||
stop flashing. |
|
|
|
|
|
|
6.If you wish to disconnect the iron, hold the “increase temperature” setting (6) down for 2 seconds (Fig. D). The screen will go off with a beep.
7.Unplug the iron and let it cool down before storing it away.
8.SPRAY
To use this function there must be water in the reservoir. If you wish to obtain a spray of water to dampen dry or
N.B.: It may be necessary to press the spray button several times to activate this function.
9. EXTRA STEAM
Switch the iron on, as indicated in Section 6 “Steam ironing”. When the iron has reached the temperature selected, press the extra steam button (3) while ironing and the steam will come through the holes in the sole (Fig. F) onto the fabric, smoothing out the most difficult creases. Wait for at least 5 seconds between each use of the extra
steam button so as to allow the iron to heat up again and thereby obtain the maximum amount of extra steam.
Upright steam: The extra steam function also works when the iron is in an upright position. To use this function, hold the iron upright around
CAUTION: Do not direct the iron towards people as the temperature of the steam is very high.
10. AUTOMATIC SHUT-OFF
The
•Automatic
•Automatic shut-off in the upright position:
If the iron remains immobile for 8 minutes on its support base (upright), the iron will disconnect automatically. “AUTOMATIC
11.LANGUAGE SELECTION
Hold the “lower temperature” setting down for 2 seconds (7) (Fig. H). EN will appear on the LCD screen (4). Press the “lower temperature” setting (7) again to change the language. The language will change from EN (English ) to DE (German), and from DE to FR (French). To select the desired language, press the “increase temperature” setting (6) and the language selected will be set.. N.B.: The default language is English.
13