7500EXL Extended Life Generator
ASSEMBLY
Your generator requires some assembly and is ready for use after it has been properly serviced with the recommended oil and fuel.
If you have any problems with the assembly of your generator, please call the generator helpline at
•Battery Charge Cables
•Spare Spark Plug,Air Filter, and Oil Filter
•Spark Plug Wrench
•(2) Locking 30 Amp Plugs
•Engine Oil
•Operator's Manual
•Engine Manual
If any parts are missing or damaged, call the generator helpline at
Unpack the Generator
1.Set the carton on a rigid flat surface.
2.Open carton completely by cutting each corner from top to bottom.
3.Remove everything from carton except generator.
4.Leave generator on carton to install wheel kit.
Carton Contents
Check all contents against those listed below:
•Generator
•Wheel kit
•Storage Cover
•Adapter Cord Set
•Battery
•Battery Float Charger
Install Wheel Kit
The wheel kit is designed to greatly improve the portability of your generator.
NOTE: Wheel kit is not intended for
•1/2" or 13mm socket wrench
•1/2" or 13mm open end wrench
•7/16" socket wrench
•7/16" open end wrench
•Pliers
•Safety glasses
Refer to Figure 1 and install the wheel kit as follows:
1.Tip generator so that engine end is up.
Figure 1 — Install Wheel Kit
Axle |
Wheel |
Flat Washer |
1/4x20 Lock Nut |
Support Leg |
M8x20mm Capscrew |
Vibration Mount |
M8 Lock Nut |
6 |