GeneracPortableProducts2,400PSIHighPressureWasher
IMPORTANT: | Read entire owner'smanual before you | PREPARING | PRESSURE | |
attempt to assembleor operate your new pressure washer. | WASHER | FOR USE | ||
REMOVE | PRESSURE | |||
|
| |||
WASHER FROM
CARTON
•Remove the parts box includedwith pressure washer.
•Slice two corners at the end of carton from top to bottom so the panel can be folded down fiat, then remove all packing material.
•Roll pressure washer out of carton.
Carton Contents
Items in the carton include:
Main Unit
Parts Box (which includesthe following):
Goggles
Handle Assembly
Handle Fastening Hardware (which includes): Carriage Bolts (2)
Plastic Knobs (2)
"J" Hook
Chemical Hose Clip
Nozzle Cleaning Kit
High Pressure Hose
Quick Connect
Owner'sManual
EngineManual
Owner'sRegistration Card
Spray Gun
Nozzle Extension
Oit Bottle
If any of the above parts are missing or damaged,call the pressure washer helpline at
If you have any problems with the assemblyof your pressure washer or if parts are missing or damaged,call the pressure washer helpline at
To prepare your pressure washer for operation, you will need to perform these tasks:
•Fill out and send in the registration card.
•Attach the handle.
•Add oil to the engine crankcase.
•Add fuel to the fuel tank.
•Connect the high pressure hose to the spray gun and the pump.
•Connect the water supply to the pump.
Attach Handle
NOTE: All assemblyoperations given in this section will be described from the perspective of assemblingthe pressure washer from the rear.
•Placethe handle onto the handle supports already connected to the main unit. Make sure the holes in the
handle align with the holes on the handle supports (Figure I).
Handle
Supports
NOTE: It may be necessaryto move the handle supports from side to side in order to alignthe handle so it will slide over the handle supports.
/
5
