GeneracPortableProducts2,400PSIHighPressureWasher
NOTE: Your pressure washer comes with a quick connect that you can use to attach the high pressure hose to either the pump or spraygun.
•Uncoil the high pressure hose and attach the female quick connect to one end of the hose. Attach the male quick connect to the high pressure fitting on the pump (Figure 7).
• Run water through your garden hose for 30 seconds to clean out any debris. Turn off water.
• Connect the garden hose to the water inlet. Tighten by hand (Figure 10).
•Attach the hose to the base of the spray gun (Figure 8). Tighten by hand.
_ ARNING! There MUST be at least ten feet of unrestricted garden hose between the pressure
washer inlet and any flow shut off device, such as a
•Turn ON the water and squeeze the trigger on the spray gun to purge the pump system of air and impurities.
•Attach the other end of the high pressure hose to the high pressure outlet on the pump (Figure 9). Pull down on the collar of the quick connect, slide onto the pump and let go of collar. Pull on hose to be sure of a tight connection.
•Before you connect your garden hose to the water inlet, inspect the inlet screen (Figure 10). Clean the screen if it contains debris, replace it if it is damaged.DO NOT RUN THE PRESSUREWASHER IFTHE SCREENIS DAMAGED.
_ | CAUTION! | Before starting the pressure washer, |
| be sure you are wearing adequate eye protection. | |
Checklist Before Starting Engine
Review the unit'sassemblyto confirm you have performed all of the following:
•Make sure the handle is in place and secure.
•Check that oil has been added to the proper level in the engine crankcase.
•Add the proper gasoline to fuel tank.
•Check for properly tightened hose connections.
•Check to make sure that there are no kinks, cuts, or damageto the high pressure hose.
•Provide a proper water supply (not to exceed 140°F) at an adequate flow.
•Be sure to read "Safety Rules" and "How To Use Your PressureWasher" before using the pressure washer.
/
7
