5500 Watt Heavy Duty Generator
Your generator requires some assembly and is ready for use after it has been properly serviced with the recommended oil and fuel.
If you have any problems with the assembly of your generator, please call the generator helpline at
IMPORTANT: Any attempt to run the unit before it has been serviced with the recommended oil will result in an engine failure.
Check all contents. If any parts are missing or damaged, call the generator helpline at
•The generator
•Generator and engine owner’s manuals
•Locking 30 Amp plug
•Engine oil
•Wheel kit
•Set the carton on a rigid flat surface with “This Side Up” arrows pointing upward.
•Carefully open the top flaps of the shipping carton.
•Cut down corners at one end of carton from top to bottom and lay that side of carton down flat.
•Remove all packing material, carton fillers, etc.
•Remove the generator from the shipping carton.
Figure 1 — Install Wheel Kit
The wheel kit is designed to greatly improve the portability of your generator.
NOTE: Wheel kit is not intended for
You will need a socket wrench with 1/2" or 13mm sockets and a
1.Place the generator on a hard flat surface.
2.Stand at the engine end of the generator and gently tilt the generator forward, high enough to place wooden blocks beneath the cradle.This will allow you to add the wheels.
Cap Screw
Hex Nut
Handle Assembly
Use existing hardware to attach left side of support leg to unit
Hex Nut
Wheel
Flat Washer
Axle
Support Leg
Cap Screw | Retaining Pin |
Vibration Mount
Flat Washer
Hex Nut
Cap Screw
4