Generac 5500XL manual Know Your Generator

Models: 5500XL

1 18
Download 18 pages 18.53 Kb
Page 4
Image 4
KNOW YOUR GENERATOR

Generac Portable Products 5500XL Extended Life Generator

KNOW YOUR GENERATOR

Read this owner’s manual and safety rules before operating your generator.

Compare the illustrations with your generator, to familiarize yourself with the locations of various controls and adjustments. Save this manual for future reference.

Fuel Tank

 

 

 

Circuit Breakers (AC)

 

 

Recoil Starter

 

 

 

Choke Lever

120 Volt AC, 30 Amp

 

 

Air Cleaner

Receptacle

 

 

 

120/240 Volt AC,

 

 

Run/Stop Switch

30 Amp Receptacle

 

 

 

12 Volt DC, 10 Amp

 

 

 

Receptacle

 

 

 

 

 

 

Spark Arrester Muffler

120 Volt AC, 15 Amp

 

 

Idle Control Switch

Receptacles

Grounding Wing Nut

 

 

12 Volt DC, 10 Amp Receptacle — Recharge a

Circuit Breakers (AC) — Each receptacle is provided

discharged 12 Volt automotive type battery through

with a circuit breaker to protect the generator against

this receptacle.

 

electrical overload. Breakers are "push to reset" type.

120 Volt AC, 15 Amp Receptacles — May be used to supply electrical power for the operation of 120 Volt AC, 15 Amp, single phase, 60 Hz electrical lighting, appliance, tool and motor loads.

120 Volt AC, 30 Amp Locking Receptacle — May be used to supply electrical power for the operation of

120 Volt AC, 30 Amp, single phase, 60 Hz electrical lighting, appliance, tool and motor loads.

120/240 Volt AC, 30 Amp Locking Receptacle — May be used to supply electrical power for the operation of 120 and/or 240 Volt AC, 30 Amp, single phase, 60 Hz electrical lighting, appliance, tool and motor loads.

Air Cleaner — Uses a dry type filter element and foam pre-cleaner to limit the amount of dirt and dust sucked into the engine.

Choke Lever — Used when starting a cold engine.

Fuel Tank — Capacity of seven (7) U.S. gallons.

Grounding Wing Nut — Used for proper grounding of unit.

Idle Control Switch — With this switch set to ON, printed circuit board in control panel automatically reduces engine speed when no load is connected and increases engine to proper speed when load is applied. However, be sure switch is OFF when starting engine.

Recoil Starter — Used for starting the engine.

Run/Stop Switch — Set this switch to "RUN" before using recoil starter. Set switch to "STOP" to switch OFF engine.

Spark Arrester Muffler — Exhaust muffler lowers engine noise and is equipped with a spark arrester screen.

4

Page 4
Image 4
Generac 5500XL manual Know Your Generator