Generac Power SYSTEMS, INC | Generac Power Systems R-200A instruction

GENERAC® POWER SYSTEMS, INC.

P.O. BOX 8

WAUKESHA, WI 53187

Part No. 0G1341

Revision E (06/19/07)

Printed in U.S.A.

Image 16

Generac Power Systems R-200A technical manual Generac Power SYSTEMS, INC

Contents

Technical Manual  General Hazards  Authorized Service Dealer Location Table of Contents Control Board DIP Switch & Jumper Settings Introduction Dip Switch & Jumper Settings Old Revision Switch Position Condition System Low Utility Restored Generator OperationEngine Timing Utility Failure Active Alarm Normal Exercise ModeRE-CRANK Auto Start LOW Battery RED LED Indicator System Ready Green LED IndicatorLOW Fuel Pressure Yellow LED Indicator LOW OIL Pressure RED LED Indicator RPM Signal Failure Flashing RED Overspeed Indicator Overcrank RED LED IndicatorAlarm Cancel Automatic Transfer Switch ATS Mode Engineered Transfer Switch 2-WIRE Start GTS Mode Voltage Regulator Adjustment Line NEU GND 2A and 10A Battery Chargers ‹ R-200A J2 Connector 14 PIN White ‹ 2A, 12VDC Battery Charger ‹ 10A, 12VDC Battery Charger Panel Technical Manual Generac Power SYSTEMS, INC