Generac Power Systems R-200A technical manual Switch Position Condition System Low

General Information

R-panel Technical Manual

								Switch Position
Condition	System	Low	Low	Low	High	Over	Over	Manual	Auto	Off
	Ready	Fuel	Bat	Oil	Temp	Speed	Crank
Generator Switch is	OFF	@	X	OFF	OFF	OFF	OFF			O
in the OFF Mode
System Ready for	ON	@	X	OFF	OFF	OFF	OFF		O
Automatic Start
Generator Switch is	OFF	@	X	OFF	OFF	OFF	OFF	O
in the MANUAL Mode
Weekly Exerciser	X	@	Flashing	Flashing	Flashing	Flashing	Flashing	O	O	O
is not Set (Note A)			(---------------------------------------1 sec rate -------------------------------------)
Battery Voltage <12.2V	X	@	ON					O	O	O
for > 1 minute			(Non-Latching)
Battery Voltage <6V	OFF	@	ON					O	O
For > 0.05 seconds
Unit Shutdown due	OFF	@	X	ON				O	O
To Low Oil Pressure
Unit Shutdown due	OFF	@	X		ON			O	O
To High Cooant Temp
Unit Shutdown due	OFF	@	X			ON		O	O
To Engine Overspeed
Unit Failed to Start	OFF	@	X				ON	O	O
During it's Crank Cycle
Utility Voltage is	Flashing	@	X					O	O
< 60% of Nominal	1 sec rate
Unit Shutdown due	OFF	@	X		Flashing			O	O
To Low Coolant Level
Engine Speed Signal	OFF	@	X			Flashing		O	O
Fault/RPM Signal Loss
Control Board is	Flashing	@	X					O	O	O
In GTS Mode	5 sec ON, 1 sec OFF
DIP Switch #5 is	OFF	@	ON	ON	ON	ON	ON	O	O	O
not set correctly

@= Low Fuel Pressure is a Yellow LED and will be ON when fuel pressure is less than 5 inches Water Column X = indicates that the LED can be ON or OFF depending on the Operating Mode (i.e. Manual, OFF or Auto) Note A: a RED LED fault indication has priority over the flashing LED's used to indicate exercise time not set

4