lettering.
When you connect the woofer tower outputs pay close attention to the way the connector works. It only goes in one way and you cannot put it in wrong. However, you can fail to put it in all the way or fail to lock it in place. Line up the alignment pins on the connectors, push the plug in, and twist it clockwise until the lock "clicks" in place to keep it there. By looking carefully, it will be obvious as to how it works.
At the AMPLIFIER end of the servo-bass cable, you will find a male 1/8” jack. The female end is on the chassis of the servo-bass amplifier labelled GND. These jacks are used for grounding an internal shield within the servo-bass cable. For the time being, leave this shield disconnected. The shield ground should be used only when necessary.
Midrange/Tweeter Connections
Next, connect the mid/tweeter panels to your power amplifier using a pair of high quality loudspeaker cables (not supplied) to the 5-way binding posts. We recommend using good quality spade connectors for this job.
There are two ways to get the music signal from your hifi
system to the Servo-Controlled Bass Amplifier to drive the woofers. The first, and preferred way is to drive it using the output of the power amplifier that is driving the midrange/ tweeter panels using the supplied pair of Servo-Bass Interconnects.
The Servo-Bass Interconnect will be supplied with a pair of banana plugs at one end, and an XLR balanced male plug at the other end. The banana plugs will plug straight into the binding posts of the G2 midrange/tweeter tower inputs when you are using speaker cables with spade connectors. If your speaker cables use banana plugs, you can order spade connectors with the SBI at no extra charge when you order your loudspeakers.
The XLR connector contains a specially developed internal
