Genie 3681036666 Troubleshooting Guide, Safe=T=Beam System Self=Diagnostic Troubleshooting

SCHEDULED MAINTENANCE

AMonthly:

oDoor springs and door hardware:

-Oil door roller, bearings, and hinges using silicone lubricant or light oil.

Reattach Carriage Assembly to Rail Assembly:

a.Pull the Emergency Release Knobtoward Power Head.

b.Close door.

Contact Reverse Test,

-Perform Adjustment Step 2 on page 8.

A WARNIN J

AWARNING

--Do not operate door auto atiCally 0r man_al/y if Springs			Ifthe door fails to reverse on contact with the board,
are broken, Contact a Genie Fact0ry Authorized Dealer for
			adjust the Close Force Control as specified in Set Limit
service or call Customer Service at 1,800,35'GENIE.		!
			Switches and Force Controls on page 9. If the Opener still
• Balance Door.			fails, contact a Genie Factory Authorized Dealer for service
-	Close door.		or call Customer Service at 1-800-35-GENIE.
- ReleaseCarriage Assembly from Rail Assembly by pulling			FCC AND IC CERTIFIED
	down on Emergency Release Knob.
- Raisedoor manually 3'-4'and verify that door stays at
	that position. See Check Step 2 on page 4.		All devices comply with Part 15 of the FCCRules.
	NOTE
			Operation is subject to the following two conditions: (1)
When the door is 3'-4'above the ground, the door			this device may not cause harmful interference, and (2)
			this device must accept any interference received, includ-
should	stay open. Slight movement isacceptable.	If
			ing interference that may cause undesired operation.

the door moves too much, contact a Genie Factory
Authorized Dealer for service or call Customer Service at	B As Needed:
1=800=35=GENIE.	• Replace Light Bulb

TROUBLESHOOTING GUIDE

Safe=T=Beam ® System Self=Diagnostic Troubleshooting

Source (Red LED) Sensor (Green LED)

ONON

OFFOFF

OFFON

2 BLINKS, Pause

(Repeat)ON

Possible Problem

Normal operation

o Power Head not powered

o Wiring from Power Head bad

o Wiring to Source missing or bad o Power has been interrupted

o Beam not aligned o Beam obstructed o Sensor defective

Solution

None required

. Check breakers, fuses, plugs

. Check wiring for obvious shorts

. Check wiring

. Remove power and reapply

. Check Source, Sensor alignment

. Check for obstruction

. Contact Customer Service

2 BLINKS, Pause	OFF	o Wire to Sensor			missing or bad
(Repeat)		o Sensor		defective
3 BLINKS, Pause		o Sensor		receiving	interference
(Repeat)
	ON
4 BLINKS, Pause	ON	.	Source	not sending pulses
(Repeat)		.	Source	defective

o Check wiring

o Contact Customer Service

o Determine source of interference

o Check for sunlight or another opener on nearby door

. Contact Customer Service

o Contact Customer Service

. Contact Customer Service

10 For Help, call 1=800-35-GENIE or visit www.geniecompany.com