Genz-Benz 60LT owner manual

HEADPHONE JACK -This jack, located on the rear panel, allows the user to enjoy the tone of this amp through standard headphones (8-600 ohms). A speaker switch shuts off the internal speakers.

EFFECTS CANCEL JACK - A ¼” effects cancel jack is provided on the back panel to mute the internal effects via footswitch. Any standard single button latching footswitch (with shielded cable) may be used. Signal is muted when the switch is closed.

POWER AMPLIFIER -The Shenandoah™ Stereo 60LT contains an advanced stereo monolithic power amplifier circuit that is completely protected against overloads, short circuits and thermal faults. Output is rated at 30 watts per side (60 watts total) into 4 ohms, with excellent overload recovery characteristics.

IEC POWER INLET CONNECTOR -TheShenandoah™ Stereo 60LT uses a detachable power cord and

is shipped from the factory with the appropriate power inlet cable and connector for the market the amplifier was shipped to. There is an AC mains fuse located in a small drawer within this molded connector.

PHANTOM POWER - An internal phantom power source (12 volts) is provided for use with condenser mics.

This power source is on at all times and does not affect the standard operation of the amp, even when a condenser mic is not used. We use the DIN 45-596-P12 volt standard which will operate virtually all of the live sound reinforcement condenser microphones on the market. Some “boutique” externally biased condenser mics will not

be compatible and will require 48 volt phantom power. We suggested live sound condenser mics by: AKG, Audio Technica, Shure and Crown.

SPEAKER OUTPUT JACK - The Shenandoah™ Stereo 60LT provides left and right ¼” speaker output jacks. Minimum total load is 4 ohms per side.

SPEAKER COMPLIMENT - The Shenandoah™ Stereo 60LT utilizes two specially designed 6.5” woofers and dual compression tweeters. The cabinet features a front port for more rounded low frequency response. The impedance of the internal speakers is 4 ohms per side.

MONITOR SHAPED CABINET DESIGN - The Shenandoah™ Stereo 60LT utilizes lightweight plywood to help reduce weight. This cabinet design offers two platforms so the cabinet can be used in the normal upright position or tipped back towards the performer for more of a monitoring situation. Leaning the cabinet back can change the tone of the amp and reduce boomy low frequencies.

SPEAKER STAND MOUNT - A 1 1/2 “ speaker stand mount is provided for use with a speaker stand.

WARNING!

. The use and operation of this device constitutes an agreement of full release of any and all liability connected with its use. Only persons familiar with the operation of high powered audio equipment should attempt to operate this device.

. In addition, by use of this device, the user agrees to hold Genz Benz and its designers, sales agents, and all other affiliates and related parties harmless in the event of any accident, injury, damage, or loss resulting from such use.

. Manufacturer’s sole responsibility is to provide a warranty on the specified performance of the product under normal operating conditions for a period of 3 years.