LEDGE

User Maintenance Instructions

(Cont.)

Replacing the Oven Light Bulb:

Your George Foreman Rotisserie Oven uses a long-lasting bulb for the oven light. However, if the light burns out, you can order replacement bulbs. When using the Oven Light in your Rotisserie Oven, we recommend using the light only as necessary to check the status of the cooking food. Do not use the light continuously during cooking as this will greatly reduce the life of the bulb.

You may order replacement bulbs by calling our Consumer Department toll free at 1-800-233-9054, email us at salton@saltonusa.com or write to:

Salton, Inc., P.O. Box 1526, Columbia, MO 65205-1526.

WARNING: Do not attempt to disassemble or clean the unit while it is plugged in and/or hot. Doing so could cause an electrical hazard.

1.Unplug Rotisserie Oven from outlet and allow to cool completely.

2.Locate light bulb compartment on inside of Rotisserie Oven (along inside front panel).

3.

Use a dime in slot of screw "A" to

 

 

GLASS

 

 

COVER

 

twist and remove screw. (Screw "A"

 

 

BRACKET

 

 

 

 

 

 

 

 

 

is the only screw with a "slotted"

 

 

 

 

 

 

 

 

head as shown in Figure 13.)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

4.

Also, remove Glass Cover Bracket.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Carefully push Glass Cover all the

SCREW

 

toward the right (away from

"A"

 

 

 

 

 

 

 

 

 

screws). Place your index finger into

 

 

 

 

 

 

 

 

 

 

 

Figure 13

 

Finger Indent and carefully lift Glass

 

 

 

 

 

 

 

 

 

 

 

 

Cover out. See Figure 14.

 

 

 

 

 

 

 

 

 

 

FINGER

 

Carefully set Glass Cover aside.

 

INDENT TABS

4.Unscrew, remove, and discard

5.

old light bulb.

 

 

 

 

 

 

 

Screw in new light bulb.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

6.

Replace Glass Cover. Be sure

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Glass Cover fits between the

LIGHT

 

 

 

 

 

 

 

 

 

 

ledge and the two small tabs as

BULB GLASS

 

shown in Figure 14.

 

 

COVER

 

 

 

 

 

 

 

 

7.

 

 

 

Figure 14

Align hole in Glass Cover Bracket

 

 

 

 

over hole in metal rim and secure

 

 

 

 

 

 

 

 

with Screw "A."

 

 

 

 

 

 

 

27