English
2-3 Integrated Peripherals
CMOS Setup
Integrated Peripherals
[Enabled] | |
[Auto] | |
x PATA IDE Set to | Ch.0 Master/Slave |
SATA Port 0/2 Set to | Ch.2 Master/Slave |
SATA Port 1/3 Set to | Ch.3 Master/Slave |
USB Controller | [Enabled] |
USB 2.0 Controller | [Enabled] |
USB Keyboard Support | [Disabled] |
USB Mouse Support | [Disabled] |
Legacy USB storage detect | [Enabled] |
Azalia Codec | [Auto] |
Onboard H/W LAN | [Enabled] |
OnBoard LAN Boot ROM | [Disabled] |
Onboard Serial Port 1 | [3F8/IRQ4] |
[Enabled] | |
Onboard Parallel Port | [378/IRQ7] |
Parallel Port Mode | [SPP] |
x ECP Mode Use DMA | 3 |
Item Help
Menu Level`
KLJI: Move | Enter: Select | F10: Save | ESC: Exit | F1: General Help | |
F5: Previous Values | F6: |
| F7: Optimized Defaults |
On-Chip Primary PCI IDE
Enabled | Enable onboard 1st channel IDE port. (Default value) |
Disabled | Disable onboard 1st channel IDE port. |
On-Chip SATA Mode
Disabled | Disable this function. |
Auto | BIOS will auto detect. (Default value) |
Combined | Set |
| the motherboard; 2 for SATA and the other for PATA. |
Enhanced | Set |
| HDDs to use; 4 SATA HDDs plus PATA HDDs. |
Set | |
| PATA mode. Support a maximum of 4 SATA devices. PATA devices will be |
| ignored. |
PATA IDE Set to
Ch.1 | Master/Slave | Set PATA IDE to Ch. 1 Master/Slave. |
Ch.0 | Master/Slave | Set PATA IDE to Ch. 0 Master/Slave. (Default value) |
SATA Port 0/2 Set to
This value will auto make by the setting
If PATA IDE were set to Ch. 1 Master/Slave,this function will auto set to Ch. 0 Master/Slave.
SATA Port 1/3 Set to
This value will auto make by the setting
If PATA IDE were set to Ch. 0 Master/Slave,this function will auto set to Ch. 1 Master/Slave.
- 36 - |