Installing Your Cooker
Your Belling Cooker | Even if you have used an electric cooker before, it is important that you read | |
| these instructions thoroughly before starting to cook, paying particular attention | |
| to the installation and safety instructions. |
|
Getting help | If you have any problems with installing, operating, or cooking with your Belling | |
| Cooker, please check through these instructions thoroughly to make sure that | |
| you have not missed anything. If you still need help, then please contact: |
|
| Belling Customer Care Centre |
|
| Stoney Lane |
|
| Prescot |
|
| Merseyside |
|
| L35 2XW |
|
| Tel 0844 815 3746 |
|
| If your query relates to cooking then please write to the Senior Home |
|
| Economist at the same address. |
|
| Details of how to contact a Belling Approved Service Agent, should your | cooker |
| ever require maintenance, can be found in the ‘Care of your cooker’ section of | |
| this book. Please quote the cooker model and serial number with all enquiries, | |
| this can be found on the voltage label which is located on the outer back panel. | |
| WARNING! For your own safety, make sure that these instructions on | |
| installation, use and maintenance are followed. |
|
| We advise you to keep these instructions in a safe place for future reference. if | |
| you sell or transfer ownership of this product, please pass on these instructions | |
| to the new owner. |
|
| This appliance is not intended for use by persons (including children) with |
|
| reduced physical, sensory or mental capabilities, or lack of experience and | |
| knowledge, unless they have been given supervision or instruction concerning | |
| use of the appliance by a person responsible for their safety. |
|
Unpacking | After unpacking your cooker, make sure that you remove all the packing from the | |
| oven and grill compartment, and the packing from under the hob on radiant ring | |
| models, and any stickers from the oven door and the hob. Examine your cooker | |
| for any damage. If there is any damage to your cooker or anything is missing, | |
| please contact your supplier for advice. |
|
Locating the cooker | Your cooker must stand on a flat surface, or be fitted to the special Belling stand, | |
| so that when it is in position the hob is level. Make sure that the cooker is stable | |
| and cannot be rocked. If it is used between units, allow 10mm (3/8”) clearance | |
| on each side. It must not be situated with either side closer than 150mm (6”) to a | |
| wall or cupboard that is higher than the hob. Do not remove the cooker feet. | |
| Any overhanging surface or cooker hood should be at least 450mm (18”) | above |
| the cooker hob. We do not recommend positioning the cooker below wall |
|
| cupboards, as the heat and steam from the cooker may cause damage to the | |
| cupboards and its contents. Make sure that the walls near the cooker are |
|
| resistant to heat, steam, and condensation. |
|
2
