POWER SUPPLY CORD SELECTION

If your line voltage is 220 to 240V, use one of the following types of cable.

Plug

 

 

configuration

Plug type

Line voltage

 

EURO

220 – 240V

UK

220 – 240V

Use a 5A fuse which is approved by ASTA or BSI to BSI362.

Always replace the fuse cover after changing the fuse.

Plug

configuration Plug type Line voltage

Australian 240V 10A

Switzerland 200 – 240V 240V

6A

North

200 – 240V

American 240V 15A

IMPORTANT PRECAUTIONS

Save Original Packing Materials

The original shipping carton and packing materials will come in handy if you ever have to ship your projector. For maximum protection, repack the set as it was originally packed at the factory.

Moisture Condensation

Never operate this unit immediately after moving it from a cold location to a warm location. When the unit is exposed to such a change in temperature, moisture may condense on the crucial internal parts. To prevent the unit from possible damage, do not use the unit for at least 2 hours when there is an extreme or sudden change in temperature.

Place and Manner of Installation

Do not place in hot locations, such as near heating equipment. Doing so could cause mal- function, and shorten the life of the projector.

Avoid locations with oil or cigarette smoke. Doing so will dirty the optical parts, shortening their lives, and darkening the screen.

Do not use in angle of 20or more degrees. Doing so could shorten the life of the lamp.

If used at high altitudes, the unit could cease operation even if used within the rated tempera- ture range. This is because the thinner air at high altitudes decreases the internal cooling efficiency. Therefore, please lower the ambient temperature if using at high altitudes.

8

Page 8
Image 8
Toshiba TDP-MT500 owner manual Power Supply Cord Selection, Important Precautions, Save Original Packing Materials