Toshiba TDP-MT500 Note-book type computer, Press POWER button again, Viewing Computer Images

VIEWING COMPUTER IMAGES

Main power switch

TELE WIDE

MENU/EXIT ENTER

POWER		POWER button/
	LAMP	POWER indicator
	TEMP

POWER ON/OFF
POWER button	SOURCE
C1	C2		DVI
			D
COMP1	COMP2		DVI-D
S		V	DVI
			A
S-VIDEO	VIDEO		DVI-A
16:9	4:3		ZM
16:9	4:3		ZOOM
REAL			DYN
REAL	ASPECT		DYNAMIC
	2	3
1
	ENTER
MENU			EXIT
CNT	BRI	COL	TIN
CONTRAST BRIGHT		COLOR	TINT
TEM	GAM	SH
COLOR	GAMMA SHARPNESS

TEMP

LIGHT

LIGHT

When stopping projection:

8 Press POWER () button.

•A confirmation message appears on the screen.

•To cancel this state, wait for a while, or press EXIT but- ton or MENU button of the remote controller, or press MENU/EXIT button of the projector.

9 Press POWER () button again.

•The light-source lamp comes off and the projector comes to standby state. At this time POWER indicator blinks in orange.

10 Wait about 2 minutes until POWER indicator comes on in orange.

•Wait about 2 minutes in standby state, because during this time the intake/exhaust fan is turning to cool down the light-source lamp.

•The intake/exhaust fan continues to turn for about one minute after POWER indicator has come on in orange.

•Do not turn off the main power switch while POWER in- dicator is blinking. If the main power switch is turned off immediately after use, the projector may fall in failure.

•The fan generates a loud sound while cooling down, but it is not a failure.

11 Turn “OFF” the main power switch (Turn to indication O).

•When the projector is not used for a long time, unplug the power plug from the power outlet for safety.

•Set the lens cap to prevent dust from being gathered from outside.

Note-book type computer

When the projector is connected to a note-book type computer, the picture images from the computer may not be projected on screen. On this occasion, setup the computer so that it may output picture signals. How to setup the computer depends on the type of the computer. Refer to the instruction manual of the computer.

Example of setup for the external output:

Press “Fn” key and any of “F1” to “F12” key (Depends on the type of the computer).

26