Toshiba TDP-MT500 Cleaning dust in the intake vent, Cleaning the projector, Cleaning the lens

(b)

Holder

�(a)

TELE WIDE

	▲ button
MENU/EXIT	ENTER▼ button
POWER	POWER button
	LAMP
	TEMP

REPLACING THE LAMP / CLEANING THE PROJECTOR

5 Holding the holder, pull out the light-source lamp from the unit.

•Pull out the light-source lamp slowly. If the lamp is burst, the glass fragments may be scattered if the lamp is pulled out hurriedly.

•Do not spray water or the like over the light-source lamp pulled out, or do not put it where children can access it or near anything easily flammable. It may cause burn or injury.

6Holding the holder of a new lamp, insert the lamp to the bottom fitting the lamp to the shape of the hole in the unit.

7Press the holder into the storage.

•Make sure that the holder is securely locked.

8Securely screw down the three fixing screws

(b) with the Phillips screwdriver.

9Insert the lamp cover into the unit, and se- curely screw down the screw (a) with the

Phillips screwdriver to fix the lamp cover.

•If the lamp cover is dislocated, the power can not be turned on.

10 Turn on the power.

11 Simultaneously press on {, } buttons and POWER button ( ) on the operation panel of the unit for more than 3 seconds.

•If the three buttons are not pressed simultaneously, the lamp-used- hours may not be reset.

•If the lamp-used-hours have exceeded 1500 hours and the lamp has been replaced, it is not possible to turn on the new light-source lamp until the lamp-used-hours are reset.

•Do not reset the lamp-used-hours if the lamp is not replaced.

Cleaning dust in the intake vent

If dust is accumulated in the intake vent, the temperature in the projec- tor goes up abnormally, and may

damage the internal parts. Also, the light-source lamp may come off to protect the internal parts. Clean up

the dust with a vacuum cleaner about once a year.

Exhaust vent

Intake vent

Cleaning the projector

Softly wipe off dirt on the projector with a soft cloth.

•If the dirt is thick, wipe it off with a cloth soaked in a neutral detergent diluted with water, and then finish with a dry cloth.

•If any pesticide is sprayed over the projector, or if the projector is wiped with benzine or thinner, or if rubber or vinyl products are brought into contact with the projector for a long period of time, the painting of the projector may change in quality or removed.

Cleaning the lens

Remove dust or dirt on the lens with a commercially available lens cleaning kit (blower, brush, and the like).

•Because the surface of the lens is easily scratched, do not rub or hit the surface with anything hard.

35