Toshiba TDP-MT500 owner manual Making projection, Press Power button, Select an input signal

LAMP

TEMP

Lighting in orange

VIEWING VIDEO IMAGES

C. Making projection

Preparations:

•Remove the lens cap.

•Turn on power for the connected video equipment.

Main power switch

Focus ring

Zoom ring

TELE WIDE

MENU/EXIT		ENTER
POWER		POWER button /
	LAMP	POWER indicator
	TEMP

POWER button	POWER ON/OFF
		SOURCE
SOURCE button	C1	C2		DVI
	S	V		A
				D
	COMP1	COMP2		DVI-D
				DVI
	S-VIDEO	VIDEO		DVI-A
	16:9	4:3		ZM
	16:9	4:3		ZOOM
	REAL			DYN
	REAL	ASPECT DYNAMIC
		2	3
	1
		ENTER
	MENU			EXIT
	CNT	BRI	COL	TIN
	CONTRAST BRIGHT		COLOR	TINT
	TEM	GAM	SH
	COLOR	GAMMA SHARPNESS

TEMP

LIGHT

LIGHT

1 Turn “ON” the main power switch (Turn to indication I).

•When the main power switch is MENU/EXIT ENTER

turned on, POWER indicator comes POWER on in orange.

•If the projector finished operation without sufficient cooling, the following operation of the main power button may not work during the time when the cooling fan is turning. (At this time POWER indicator blinks in orange.) After the fan has stopped turning, press the power button again to turn on the indicator in orange.

MENU/EXIT ENTERMENU/EXITENTER

POWER	Blinking in green	POWER	Lighting in green
	LAMP		LAMP
	TEMP		TEMP

Power can not be turned “ON” or “OFF”.

2 Press POWER () button.

•It may take about one minute for the lamp to come on.

•On rare occasions, the lamp may fail to come on. At this time, turn on the lamp again after a few minutes.

3 Select an input signal.

•Press one of SOURCE buttons (VIDEO, S-VIDEO, COMPONENT 1, COMPONENT 2, DVI-DIGITAL, or DVI-ANALOG button) ac- cording to the connected input terminal.

•Select the input signal after video image is projected on the screen.

•With this projector, the input signal is selected from the input sig- nal sources contained in the signal setting menu. (See Page 26 for the details.)

•Some projected picture images may be made easy to see by chang- ing ASPECT (image angle). (See Page 20 for the details.)

4Set the projector after adjusting the projec- tion distance to obtain specified image frame size.

5Set the projector and screen so that they may face perpendicular to each other. (See

Page 11.)

•If the projector and the screen can not be made perpendicular to each other, adjust the projection angle. (See Page 11.)

6. Adjust size of the projected image by turn- ing the zoom ring.

•It is possible to change image size by varying the distance from the projector to the screen.

7. Adjust focus by turning the focus ring.

21