Additional safety rules for nailers
1.Use only the nail types indicated in this manual. Use of accessories that are not designed for this tool could result in personal injury and / or damage to the tool.
2.Do not touch metal parts of tool during operation. Hold only the handle or housing of the tool.
3.Do not activate the trigger switch unless the nail is in contact with the workpiece. Serious injury can result from improper operation.
4.The tool should only be used for the purpose it was designed as outlined in this manual. Do not use it on hard surfaces like rock or concrete. Personal injury or damage to the tool could result.
5.Take care when nailing thin material. Special caution must be taken for possible penetration of nails through thin material. This could cause harm to anyone behind the workpiece or in the immediate area.
6.Do not overheat the tool. During operation, the nailer may feel warm to the touch. This is normal. However, if the nailer starts to feel hot, discontinue use until the unit cools down.
The tool must be used only for its prescribed purpose.
Any use other than those mentioned in this manual will be considered a case of misuse. The user and not the manufacturer shall be liable for any damage or injury resulting from such cases of misuse.
To use this tool properly, you must observe the safety regulations, the assembly instructions and the operating instructions to be found in this manual. All persons who use and service the machine have to be acquainted with this manual and must be informed about its potential hazards. Children and infirm people must not use this tool. Children should be supervised at all times if they are in the area in which the tool is being used. It is also imperative that you observe the accident prevention regulations in force in your area. The same applies for general rules of occupational health and safety.
The manufacturer shall not be liable for any changes made to the tool nor for any damage resulting from such changes.
Even when the tool is used as prescribed it is not possible to eliminate all residual risk factors. The following hazards may arise in connection with the tool’s construction and design:
1.Damage to hearing if ear protection is not worn.
2.Injury from nails if the safety instructions are not followed.
6
