them to support the workpiece (Fig. L).
The side support bar locking screws (34) must be tightened to secure the support bars in position (Fig. M).
Turning on and off
1.To turn the saw on depress and hold the on/off trigger switch (24) (Fig. N).
2.To turn the saw off release the on/off trigger switch (24).
Turning on the REDEYE® laser line generator
The REDEYE® laser line generator emits 2 intense narrow beams of pure red light to guide you as you cut. It improves operator cutting vision, enables faster set- up, increases accuracy and improves safety. To turn on the laser lines press the laser light on/off switch (2) (Fig. O). To turn off the laser press the laser light on/off switch (2) one more time.
Setting the table square with the blade
1.Make sure that the electrical plug is removed from the power point.
2.Push the saw arm (5) down to its lowest position and engage the release
M
N
O
P
knob (6) to hold the saw arm in the transport position.
3.Loosen the mitre lock (25) (Fig. P).
4.Rotate the table (21) until the pointer is positioned at 0º.
5.Tighten the mitre lock (25).
6.Loosen the bevel lock (16) Q
and set the saw arm (5) at 0º bevel (the blade at 90º to the mitre table). Tighten the bevel lock (16) (Fig. Q).
7.Place a set square against the table (21) and the flat part of the blade. (Fig. R)
Note. Make sure that
the square contacts the flat R part of the saw blade, not
the teeth.
8.Rotate the blade by hand and check the
9.The edge of the set square
and the saw blade should be parallel.
10.If the saw blade angles away from the set square, adjust as follows.
11.Use a 13mm wrench or adjustable wrench to loosen the lock nut securing the 0° bevel adjustment screw (35) (Fig. S). Also, loosen the bevel lock (16).
S |
| T |
|
|
|
12
