Global Machinery Company CDB305MS Setting the fence square with the table, Changing a blade

12.Adjust the 0° bevel adjustment screw (30) with the 6mm hex key to bring the saw blade into alignment with the square (Fig. T).

13.Loosen the 2 Phillips

head screws holding U

the pointer of the bevel scale (17) and adjust the position of the pointer so that it accurately indicates zero on the scale (Fig. U). Retighten the screw.

14.Retighten the bevel lock (16) and the lock nut

securing the 0° bevel	V
adjustment screw (30).

Note. The above procedure can also be used to check the angle of the saw blade to the table at either 45º bevel angle to the left or to the right. The 45° bevel adjustment screws (28 & 29) are on opposite

sides of the saw arm. You W will require a 13mm wrench

or adjustable wrench (not supplied) for the lock nut (Fig. V) and the 6mm hex key for the set screws (Fig. W).

Setting the fence square with the table

1.Make sure that the

electrical plug is removed from the power point.

2.Push the saw arm (5) down to its lowest position and engage the release knob (6) to hold the saw arm in the transport position.

3.Loosen the mitre lock (25).

4.Rotate the table (21) until the pointer is positioned at 0º.

5.	Tighten the mitre lock (25).
		X
6.	Using the 6mm hex key
	loosen the hex screw
	securing the top piece of
	the right hand side fence
	(Fig. X) and remove this
	top section.

7.Using the 6mm hex key provided, loosen the four screws securing the fence (19) to the base (Fig. Y).

8. Place a square against the		Y
fence (19) and alongside
the blade (Fig. Z).
9. Adjust the fence (19) until it
is square with the blade.
10.	Tighten the screws
	securing the fence (19).
11.	Loosen the Phillips head
		Z
	screw holding the pointer
	of the mitre scale (22)
	and adjust it so that it
	accurately indicates the
	zero position on the mitre
	scale (Fig. a).
12.	Retighten the screw
	securing the mitre
	scale pointer.
13.	Replace the top section	a

of the fence and secure the hex screw using the 6mm hex key.

Changing a blade

DANGER! Never try to use a blade larger than the stated capacity of the saw. It might

come into contact with the blade guards. Never use a blade

13