16.Fit the table lock into the table support assembly and tighten to secure the table.
17.Fit the depth scale/lock onto the handle.
18.Fit the handle and depth scale onto the motor head ensuring that the flats on the handle locate the flats on the shaft.
19.Secure the handle onto the motor head by placing the handle bolt through the middle of the handle and secure it with the 6mm hex key.
20.Fit the chuck onto the spindle and secure it by pushing it and giving it a sharp tap.
Note. Ensure both surfaces are clean before putting the chuck on the spindle.
21.Place a screwdriver through the top of the pulley cover, loosen and remove the
screw securing the pulley cover. Lift off the cover.
22.Fit the belts over the pulleys, refer to the inside of the cover for speed reference.
Note. Fit the lower belt on first.
Note. When fitting belts it is easier to place the belt onto the small pulley and then turn it onto the larger pulley.
23.To tighten the belts on the pulleys pull the motor backwards. This is best done by grabbing hold of the top of the rear pulley and the bottom of the motor housing.
24.To loosen the motor and reduce the belt tension pull the belt tension lever towards the motor and push motor forwards.
25.Replace and secure the pulley cover.
Adjustments
Adjusting the table height
Caution. Always ensure that the drill press is switched off and the plug is removed from the power point before making any adjustments.
1.Loosen the table lock.
2.Rotate the handle in a clockwise direction to raise the table.
3.Rotate the handle in an
4.Tighten the table lock to secure the table.
Adjusting the table angle
Caution. Always ensure that the drill press is switched off and the plug is removed from the power point before making any adjustments.
11
