Assembly
Stand set-up
1.Place the table saw on the floor (fig A).
2.On the left hand side extension table which was packed separately from the table saw remove the 2
3.Fit the left hand side extension table into the 2 positioning holes on the left hand side of the table saw, the extension table locking knobs (28) may need to be loosened if it is a tight fit (fig B).
A |
| B |
|
|
|
C |
| D |
|
|
|
4.Replace the 2
Note: The guide rods can be rotated slightly to gain access to the screw holes.
5.Ensure the left hand side extension table is fully inserted and tighten the extension table locking knobs to secure it in position (fig D).
6.Using the handle on the table saw (4) and the soft grip handle on the lower leg (5) gently tilt
the table saw onto its | E |
left hand side. |
7.Push the stand locking lever (29) to the left to disengage the stand assembly and fold open the stand legs (fig E).
8.Fully open the stand legs and ensure that the stand
locking lever clicks back into place indicating that
the stand legs are securely F open (fig F ).
9.Using the handle on the table saw (4) and the soft grip handle on the lower leg (5) tilt the table saw onto its stand (fig G).
Important. Use both handles when tilting the table onto the stand. Push down on the
leg handle (5) and pull the G table handle (4).
10.Loosen the lock nut on the adjustable foot (32) and screw the foot in or out until the table saw is stable (fig H & I).
11.Tighten the lock nut.
H |
| I |
|
|
|
10
