Cutting an extremely narrow workpiece
Longitudinal cuts in an extremely narrow workpiece with a width of 30mm or less must always be made with the help of a push block.
This table saw is not supplied with a push block. (Either make or purchase a suitable one from a specialist dealer).
Warning. Worn push blocks must be replaced without delay.
Making bevel cuts
1.Always use the fence when cutting bevels.
2.Set the saw blade to the required angle using the blade angle wheel (21).
3.Set the fence to suit the width and height of the workpiece using the laser line as a guide.
4.Carry out the cut in accordance with the workpiece width.
Making cross cuts
Warning. When cross cutting, do not use the rip fence
(14)as a length stop as the cut off piece could bind between the fence and the blade and cause kickback.
1.Push the mitre gauge (17) into one of the two slots of the table saw and set it to the required angle. If you also want to set the saw blade at an angle, use the slot, which prevents your hand and the mitre gauge coming into contact with the saw blade.
2.Press the workpiece firmly against the mitre gauge.
3.Switch on the saw.
4.Push the mitre gauge and the workpiece toward the saw blade in order to make the cut.
Important. Always hold the guided part of the workpiece. Never hold that part of the workpiece, which is being cut off. Always push the mitre gauge far enough forward for the workpiece to be cut through completely.
5.Switch off the saw again.
6.Wait for the saw blade to stop before removing the
Replacing the saw |
| |
l | ||
blade | ||
|
Warning. Switch off the table saw and remove the mains power plug before carrying out any adjustments, maintenance work or blade changes. Wear work gloves when handling or fitting the blade.
1. Loosen the blade lock (24) |
| |
(fig l) and turn the blade |
| |
m | ||
height handle (20) (fig m) | ||
until the saw blade is at its |
| |
maximum height. |
|
2.Loosen and remove the screw securing the table insert (13).
3.Take out the table insert (13).
4.Remove the riving knife
(8)(fig n).
5. Use the spanner supplied | n |
to lock the spindle in |
|
position (fig o). |
|
6.Use an 18mm
o |
| p |
|
|
|
17
