•Before you switch on the machine, check that all wrenches and adjustment tools have been removed.
•When you leave your workplace, switch off the motor and pull out the power plug.
•All guards and safety devices have to be refitted immediately after completion of any repairs or maintenance.
•It is imperative to observe the accident prevention regulations in force in your area as well as all other generally recognised rules of safety.
•The machine may be used in closed room only in conjunction with a suitable vacuum extraction system.
•This table saw must be connected to a
•Never use the cord for any purpose other than that for which it is intended!
•Adopt a firm standing position and keep your balance at all times.
•Check the tool for signs of damage!
•Before you use the tool it is imperative to check that its safety devices and any slightly damaged parts are working properly and in the way intended.
•Check that the moving parts work properly and do not jam or whether any of the parts are damaged. All parts must be fitted correctly and satisfy all conditions for the tool to work properly.
•Unless otherwise stated in these instructions, damaged safety devices and parts must be repaired or replaced by an authorised service facility.
•Have damaged switches replaced by an authorised service facility.
•This tool complies with the pertinent safety regulations. Repairs are to be carried out only by qualified electricians at authorised service centres, using original replacement parts. The user may suffer an accident if this condition is not observed.
•Rebating or grooving should not be carried out unless suitable guarding, such as a tunnel guard, is fitted above the table saw.
•Saws shall not be used for slotting (stopped groove).
Wear goggles • Wear earmuffs • Wear a breathing mask
Unpacking
Due to modern mass production techniques, it is unlikely that your GMC Power Tool is faulty or that a part is missing. If you find anything wrong, do not operate the tool until the parts have been replaced or the fault has been rectified. Failure to do so could result in serious personal injury.
1.Remove all loose parts from the carton.
2.Remove the packing materials from around the saw.
3.Carefully lift the saw from the carton and place it on a level work surface.
Required Tools
The following tools (not supplied) are required to assemble and maintain the table saw
•18mm spanner
•13mm spanner
•Phillips head screwdriver
7
