Projection of laser lines on the floor
Once the mounting method has been selected you may commence with the projection of the laser line.
The laser line rotating dial (2) is designed to adjust the line from horizontal to vertical and all angles in between.
Switching it on
To switch the laser line generator ON, push down the laser switch (1) and the laser will then automatically appear.
Projection of vertical laser line
Switch ON the laser line generator and adjust the rotating dial (2) anticlockwise to achieve a vertical line.
Projection of horizontal laser line
Switch ON the laser line generator and adjust the rotating dial (2) clockwise to achieve a horizontal line.
Projection of inclined laser line on the opposite surfaces
Switch ON the laser line generator and adjust the rotating dial (2) to the required inclined angle on the opposite surface.
NOTE. Position the laser line generator a maximum of 10m from the wall surface. It is recommended to use red laser
enhancing glasses (15) to improve the visibility of the laser line especially in a bright light environment.
Projection of laser line when fixed on a wall
The laser line generator is built with a large laser fan angle (up to 100° of fan beam). When this is used in conjunction with the 90° rotating system dial (2), it offers wide range of line projections across main surfaces for different alignment applications.
1.Attach the laser line generator to the pin mounting base.
2.Position this mounting
assembly onto the wall and check the vial (3) to ensure that the unit is in the general leveling position.
3.Press both the pin buttons (13) onto the dry wall and check to ensure the assembly has been securely attached.
4.Once the base has been secured you can still manouvre the laser line generator (if required) to achieve the correct horizontal level.
8
