Global Machinery Company RL 500 Emptying the grass catcher bag, Replacing the blades

Models: RL 500

1 12
Download 12 pages 61.05 Kb
Page 10
Image 10
Emptying the grass catcher bag

3.To safely operate the mower ensure all four wheels are on the ground and be careful not to loose your footing or control of the mower. Be very careful when mowing uneven or rough ground. Keep a firm grip on the handle bar at all times, always walk, never run with the mower.

4.For healthy growth, grass should not be cut too short. This can cause damage to the grass and allow weeds to develop.

5.Vary your cutting pattern from week to week, this will help to prevent matting and graining of the grass.

6.Before checking a clogged mower deck stop the engine completely and disconnect the spark plug cover and then tilt the mower so the air filter side is facing upwards. Use a stick the clear any clogged material, never use your hands.

7.Mowing wet grass should be avoided. Wet grass will clog the mower deck and if it is slippery you may loose your footing.

8.Always mow across slopes not up and down them. Be extra careful if the grass is wet as this could cause you to slip and loose control of the mower.

9.If the ground is to dry, mowing will stir up a lot of dust which may clog the air filter. In these conditions it is recommended to water your lawn the day before mowing.

10.Use the side of the mower as a guide to cut close to large objects such as a fence or a wall. Be careful when mowing over obstacles embedded in the lawn such as sprinkler systems and paving, avoid anything that sticks up above the surface of the lawn.

11.Avoid mowing over loose stones, gravel and other landscaping material as this can be picked up by the mower and flung out causing serious personal injury.

12.If the blades do come into contact with something or the mower starts to vibrate stop the engine immediately, remove the spark plug cover and inspect to see if there is any damage.

Emptying the grass catcher bag

Note. Before making any adjustment or maintenance procedures to the mower ensure it is turned off and the spark plug cover is removed.

1.To remove the catcher, raise the discharge guard, grab the catcher by the handle and lift it off the bar.

2.Empty the grass from the catcher by holding it vertical, shake it if necessary to dislodge the full contents.

Grass catcher maintenance

Warning. Check the catcher bag frequently for damage or wear, and replace it if worn.

The fabric grass catcher requires air to flow through the fabric for effective grass collection.

Wash it if necessary to restore the open mesh in the fabric.

Do not leave the fabric bag in direct sunlight, prolonged sun exposure can cause permanent breakdown of the material.

Do not leave clippings in the catcher for extended periods.

Replacing the blades

Note. Before making any adjustment or maintenance procedures to the mower ensure it is turned off and the spark plug cover is removed.

Note. Wear heavy gloves to protect your hands.

1. Tilt the mower back so the spark plug is facing up.

2

 

3

 

 

 

2.Remove the blade disc with a spanner to remove the central blade bolt first.

3.Remove all 4 single blades including the washer and nuts.

10

Page 10
Image 10
Global Machinery Company RL 500 Emptying the grass catcher bag, Replacing the blades, Grass catcher maintenance